Cleaning Stone Shower Walls - Recommended Daily to Weekly

Dry/Dust mop the floor at least twice per week.

Add two ounces of commercial marble into a clean bucket of water.

(Be sure that the bucket has been thoroughly cleaned out if it has been used before with another cleaner.)

Using a clean rayon sponge, gently apply the Marbalex on to the surface without making large puddles.

Let the surface dry. There is no rinsing required.

Cleaning Tile & Grout Shower Walls: (Daily-Weekly)

Remove all abrasive debris from the floor surface. Mix 1-2 ounces of good ceramic cleaner per gallon of warm water. With a clean bucket and clean rayon or sponge mop, apply the Ceramiclean to the surface. Let the solution dry. Rinsing is only required for heavily soiled surfaces

Sealing: (Every 1-2 years)

Surface must be dry for 6-12 Hours. Cover surrounding areas that are not intended to be sealed. Liberally spray the surface until it is wet. When the surface begins to dry within 3-5 minutes, wet the surface again with the sealer. After 30 minutes, wipe off any excess sealer with a clean and dry white terry cloth or towel.

Polishing & Enriching Color: (Monthly)

Shake the bottle before using and apply the polish to the stone surface with a clean, dry and white terry cloth towel. Let the polish dry to a haze for 2 minutes. Wipe off the haze with a clean, dry and white terry cloth towel. * Do not use on floors.

Disinfecting: (Weekly)

Simply spray Counterrific on to the surface and let it stay wet for five minutes. Wipe off with a clean and dry paper towel. If any streaks appear, simply spray again and wipe off immediately.

Restoring the Color of Grout: (As Needed)

Ensure surface is free from grease, dirt and other contaminants. Shake well with cap on before use. Remove cap, and then press pen down vertically for a minute until you see the ink starting to flow. Apply two (2) coats an hour apart. Replace cap when not in use. * If grout is dirty, clean with SCI's Ceramiclean® before using the Grout Ink. * 4. Note: Ink colors may appear slightly different from the color of the pen caps. 
  
Sealing: (Every 1-2 years)

Surface must be dry for 6-12 Hours. Cover surrounding areas that are not intended to be sealed. Liberally spray the surface until it is wet. When the surface begins to dry within 3-5 minutes, wet the surface again with the sealer. After 30 minutes, wipe off any excess sealer with a clean and dry white terry cloth or towel.

Polishing & Enriching Color: (Monthly)

Shake the bottle before using and apply the polish to the stone surface with a clean, dry and white terry cloth towel. Let the polish dry to a haze for 2 minutes. Wipe off the haze with a clean, dry and white terry cloth towel. * Do not use on floors.

Disinfecting: (Weekly)

Simply spray Counterrific on to the surface and let it stay wet for five minutes. Wipe off with a clean and dry paper towel. If any streaks appear, simply spray again and wipe off immediately.

Restoring the Color of Grout: (As Needed)

Ensure surface is free from grease, dirt and other contaminants. Shake well with cap on before use. Remove cap, and then press pen down vertically for a minute until you see the ink starting to flow. Apply two (2) coats an hour apart. Replace cap when not in use. * If grout is dirty, clean with SCI's Ceramiclean® before using the Grout Ink. * 4. Note: Ink colors may appear slightly different from the color of the pen caps.